Nasomi Community FFXI Server
https://na.nasomi.com/forum/

Utsusemi: Ichi odd
https://na.nasomi.com/forum/viewtopic.php?f=6&t=12840
Page 1 of 1

Author:  Mazorian [ Mon Dec 30, 2019 4:25 am ]
Post subject:  Utsusemi: Ichi odd

So I asked around and seems no one else is having this issue. Lv'ing my Sam as a duo and sometimes Utsusemi" Ichi is normal but 95% of the time , it takes casting past 100% (stops at 100 but motion stays) to do the animation and get the buff. I am a Nin main , I know how all of it works very well. Never seen this before and only started about a week or so ago. It's horribly affecting gameplay as at 80%ish the spell is cast and you get the buff. This is weird because the 100% is finished and my animation is still going and if if I get hit it's interrupted. Another odd thing is when it bugs the 95% of the time but casts through , it acts like :Ni and gives me a 45 second timer to recast. Anyone else having the same issue? Maybe any thread someone can point to that something is messed up in files? As Nin everything is fine , haven't tried out other jobs recently as /nin so not sure if the same. Just really bugging me and really affecting gameplay.

Author:  Mazorian [ Mon Dec 30, 2019 4:48 am ]
Post subject:  Re: Utsusemi: Ichi odd

GrendelsPRGuy wrote:
Probably go read the descriptions of Hasso and Seigan. Spell cast times and recasts are increased while those buffs are on.


Woah thanks , that's probably it for sure. I guess it all threw me off how it acts here. Much appreciated!

Author:  Arryn [ Wed Jan 01, 2020 2:33 pm ]
Post subject:  Re: Utsusemi: Ichi odd

I've had the same thing happening to me while I'm levelling BLM casting tier II nukes. The bar reaches 100% but it's another 2 seconds before the animation is finishing...

Author:  cthalupa [ Thu Jan 02, 2020 1:02 am ]
Post subject:  Re: Utsusemi: Ichi odd

Happens a lot during dynamis burns, so it's probably related to zone lag.

Author:  Kazen [ Thu Jan 02, 2020 1:28 am ]
Post subject:  Re: Utsusemi: Ichi odd

cthalupa wrote:
Happens a lot during dynamis burns, so it's probably related to zone lag.


Also, depending on the installer you used you could have .DATs for cast bars based on current retail. A lot of my casting bars end before the spells actually go off. After level cap was raised from 75, there were a good number of changes done to cast time of spells.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/